Photo of hoisting point

All things related to hull and wings

Photo of hoisting point

Postby olaf » Fri May 04, 2018 2:04 pm

Hi there,

may anyone post pictures here, how the hoisting point in the front of the boat is build?
In the documentations of the volga 70, there is only the small passage, to use the hoisting ropes, which are delivered with the boat. In Fig. 2 of the manual is shown the eye-bolt between bulkhead 5 and 6. Unfortunately this bolt was removed at my boat from a previous owner and I can´t find other documentation about that.

Can you help?

Olaf
User avatar
olaf
 
Posts: 27
Joined: Thu Aug 07, 2014 1:50 pm
Location: Mönchengladbach - Germany

Re: Photo of hoisting point

Postby Mark » Fri May 11, 2018 10:44 am

Hello Olaf,

Here a pic of my hoist point in the front.
also between 5 an 6th bulkhead.

its from a 65 Sterla.

I have seen other designs..


Regards,

Mark
Attachments
hoist56.jpg
hoist56.jpg (136.84 KiB) Viewed 75 times
Flying low in your hydro
find me on facebook:mark van Rijzen.
Mark
 
Posts: 85
Joined: Fri Jul 30, 2010 11:11 pm
Location: Near Amsterdam

Re: Photo of hoisting point

Postby olaf » Thu May 17, 2018 3:12 pm

Oh thank you, that hoisting point is removed by former owners. The iron sheet around is very rusty and I think because of that they removed it.

My plan is, to screw to anchor plates (200mm x 200mm) at the bulkhead wtih M12 screws and in the middle of the plates I will attach one of the hoisting point from stern. I replaced them by others. I hope that will work.

Best to you
Olaf
User avatar
olaf
 
Posts: 27
Joined: Thu Aug 07, 2014 1:50 pm
Location: Mönchengladbach - Germany

Re: Photo of hoisting point

Postby Mark » Wed May 23, 2018 7:16 pm

ik would try to reduce the stress of the bolds.
Use many ;-) and if possible also on the floor,
like the original.
It is only 2mm alu plate...
Flying low in your hydro
find me on facebook:mark van Rijzen.
Mark
 
Posts: 85
Joined: Fri Jul 30, 2010 11:11 pm
Location: Near Amsterdam


Return to Hull & Wings

Who is online

Users browsing this forum: No registered users and 3 guests

cron