Removing Volvo Penta

What engines to use, how to fix them, gasoline/diesel, etc
Post Reply
Westawake
Posts: 1
Joined: Sun May 13, 2018 7:34 pm

Removing Volvo Penta

Post by Westawake » Sun May 13, 2018 10:22 pm

20180512_165800.jpg
Hi all. Advice required. I am in the middle of removing my engine in order to repair/rebuild same. I have all bolts removed from the bell housing, but can only move engine forward a few inches before the sump is against the boat cross member. My question is : is there sufficient 'give' for me to lift the front of the engine approx. three inches in order to clear the cross member.
Or must I move the stern drive/bell house backwards , out of the way. Obviously I want to avoid this , in order not to have to disturb the stern seals etc.
I am also looking for a propeller for this boat and any ideas for a cost effective windscreen. I have removed the cramped cabin that someone built . It was suitable for small people only.
Attachments
20180512_165552.jpg
20180512_165435.jpg

Mark
Posts: 86
Joined: Fri Jul 30, 2010 11:11 pm
Location: Near Amsterdam
Contact:

Re: Removing Volvo Penta

Post by Mark » Thu May 24, 2018 4:41 pm

https://www.youtube.com/watch?v=Nl8JkIiX8fk

Maybe this will help??





Goodluck


Mark
Flying low in your hydro
find me on facebook:mark van Rijzen.

Post Reply